Enter code at checkout. Offer ends 21st January. *Excludes Graduated and Mirror Ranges.
Before you remove the glass from the packaging make sure you have a flat clean area slightly larger than the glass with something soft underneath to lay the glass on.
All our splashbacks are made from toughened glass and are heat resistant. They are however, susceptible to breakage if dropped on a corner or straight edge. To avoid breakage do not stand the glass up on its corner end, and do not stand the glass up on its end without something soft protecting the edges.
Do not attempt to cut drill or adjust the glass.
![]() |
![]() |
Do not lean the splashback against walls | Do not drill or hammer holes into the splashback |
Tools required:
Before you remove the glass from the packaging make sure you have a flat clean area slightly larger than the glass with something soft underneath to lay the glass on. All our splashbacks are made from toughened glass and are heat resistant. They are however, susceptible to breakage if dropped on a corner or straight edge. To avoid breakage do not stand the glass up on its corner end, and do not stand the glass up on its end without something soft protecting the edges. Do not attempt to cut drill or adjust the glass.
The glass should be adhered to a secure and permanent surface like a plastered wall or plywood. If the wall is powdery you may need to seal it with a PVA first and then wait for it to dry before adhering the glass.
![]() |
![]() |
Slight uneven surfaces may be corrected with extra silicone | Avoid touching or wetting the splashback for 24 hours following installation |